Aseptic UHT Line Commissioning
Liquid trains commissioning engineers and plant teams in the work of bringing an aseptic UHT line into service. This page explains what that work covers, at a high level. It is not a step-by-step procedure.
The work covers Tetra Pak-type aseptic UHT lines, including direct and indirect sterilizers and related process modules. Liquid does not claim to be a partner or certified trainer.
Commissioning this kind of line means preparing for the site visit, checking that the mechanical, electrical and pneumatic installation is ready, confirming utilities, powering up and setting up components, testing I/O, and setting up the process phases used in production. Where the line has a homogenizer, that setup is part of the work. The course then covers supervision during early production, troubleshooting, and a closing discussion.
These are the phase names used in Liquid’s commissioning course outlines, not a procedure:
- Preparation for commissioning
- Installation supervision and checks
- Electrical supply setup
- Component setup and I/O testing
- Homogenizer setup, where the line has one
- Sterilization
- Water circulation
- Hold / standby
- Production
- Shutdown
- Emergency empty
- CIP, including additional CIP phases used on some lines
- Aseptic test
- Production supervision and troubleshooting
The full written procedure is not published here. Qualified plants can request it through the form.
Use the form to request training for your team, or to request the full commissioning procedure if you represent a qualified plant. Write to automation@liquidconsulting.com.
Frequently Asked Questions
Do you publish the full commissioning procedure on this site?
No. This page describes the work at a high level. The full procedure is available on request to qualified plants through the form.
What kinds of lines does this commissioning training cover?
It covers aseptic UHT processing lines, including direct and indirect sterilizers and related process modules. Liquid does not claim partner or certified-trainer status.
Is this a substitute for on-site commissioning services?
No. This page is about training and about requesting the written procedure. For on-site commissioning, FAT and SAT work, see Liquid’s commissioning services.
Who can request the full procedure?
Qualified plants can request it through the form on this page, or by writing to automation@liquidconsulting.com. Liquid will review the request before sending anything.
Are step-by-step instructions included on this page?
No. The phases above are an outline of the work, not instructions to follow on live equipment.
Request Training
Tell us about your team and which course you need.